Camper van electrics: battery size, fuses and a 12 V cable size chart
A 12 V system is sized in four steps: add up what you use in a day, choose a battery that covers it, check that solar and driving bring it back, then give every cable a fuse and a cross-section. The figures below are a worked example for a typical small camper; in the planner you put in your own devices.
Open the planner Free, in your browser, no account needed
1. What you use in a day
| Consumer | Power | Hours a day | Energy a day |
|---|---|---|---|
| Compressor fridge (runs about a third of the time) | 45 W | 8 | 360 Wh |
| LED lights | 15 W | 4 | 60 Wh |
| Phones, tablet, camera | 20 W | 3 | 60 Wh |
| Laptop | 60 W | 2 | 120 Wh |
| Water pump | 40 W | 0.2 | 8 Wh |
| Roof fan | 15 W | 3 | 45 Wh |
| Total | 653 Wh |
2. How big the battery has to be
A 100 Ah lithium (LiFePO4) battery holds about 1,152 Wh you can use, because nearly all of it may be drawn (90 %). A lead (AGM) battery of the same size gives only about 600 Wh, because it should not go below half. With the consumption above that is 1.8 days on lithium and 0.9 days on AGM with nothing coming in.
3. What comes back in
A solar panel lying flat on the roof delivers roughly three quarters of its rating for each hour of full sun: about 1 hour a day in a northern winter, 3 in spring and autumn, 5 in summer. A 200 W panel therefore brings about 150 Wh in winter, 450 Wh in spring and 750 Wh in summer. A 30 A charging booster adds about 405 Wh for every hour of driving. Compare that with the daily total from step 1.
4. Fuses and cable sizes
Every cable gets its own fuse, as close to the battery or fuse box as possible. The fuse protects the cable, not the device: it sits about a quarter above the running current, and the cable must be able to carry what the fuse lets through. On 12 V the length matters as much as the current, because a thin, long cable loses voltage: the sizes here keep the loss at or below 3 % over the way there and back.
| Cable run | Current | Fuse | Cable |
|---|---|---|---|
| Battery to fuse box | 12.5 A | 20 A | 4 mm² |
| Solar charge controller to battery | 15.4 A | 20 A | 4 mm² |
| Starter battery to charging booster | 34.5 A | 50 A | 25 mm² |
| Compressor fridge (runs about a third of the time) | 3.8 A | 5 A | 1.5 mm² |
| LED lights | 1.3 A | 3 A | 0.75 mm² |
| Phones, tablet, camera | 1.7 A | 3 A | 0.75 mm² |
| Laptop | 5 A | 7.5 A | 2.5 mm² |
| Water pump | 3.3 A | 5 A | 1.5 mm² |
| Roof fan | 1.3 A | 3 A | 0.75 mm² |
12 V cable size chart
Copper cross-section in mm² for a given current and one-way cable length, for at most 3 % voltage loss at 12 V, and never thinner than the fuse allows.
| Current | Fuse | 1 m | 2 m | 4 m | 6 m | 8 m |
|---|---|---|---|---|---|---|
| 5 A | 7.5 A | 1.5 mm² | 1.5 mm² | 2.5 mm² | 4 mm² | 4 mm² |
| 10 A | 15 A | 4 mm² | 4 mm² | 4 mm² | 6 mm² | 10 mm² |
| 15 A | 20 A | 4 mm² | 4 mm² | 6 mm² | 10 mm² | 16 mm² |
| 20 A | 25 A | 6 mm² | 6 mm² | 10 mm² | 16 mm² | 16 mm² |
| 30 A | 40 A | 10 mm² | 10 mm² | 16 mm² | 25 mm² | 25 mm² |
| 50 A | 80 A | 16 mm² | 16 mm² | 25 mm² | 35 mm² | 50 mm² |
Size your own system
In VanPlanner you list your own consumers, battery, solar and booster, and get the daily balance, a wiring overview and the fuse and cable size for every run.
Open the planner Free, in your browser, no account needed